|
Q. What does
Hotwire cost to run?
A. As a simple rule HOTWIRE™ costs approximately 1 c per m2 per
hour. This is based on Hotwire running at full capacity for 30
minutes while heating and then cycling at 50% of the time following
the first 30 minutes.
Q. Is under
tile heating safe?
A. All HOTWIRE™ under tile heating elements exceed the
requirements of IEC800 standard for heating cables. We recommend
the installation of a Residual Current Device. The element is
silent and there are no odours. We use the latest technology in the
manufacture of HOTWIRE™ elements. The element is insulated with two
layers of PTFE Teflon for added safety and protection. The Earth is
a full copper braided screen. The heating wire is multi strand,
which provides flexibility and durability.
Q. Do under
tile heating systems require any
maintenance?
A. No. HOTWIRE™ is a maintenance free heating system. There are
no heating ducts or filters to clean and the heating element does
not have any moving parts to replace or overhaul. The only
possibility of damage is drilling of holes through the tiles and
damaging the cable. Be sure to consult with your installer to
determine cable location prior to drilling. We recommend
alternative to drilling holes in the tile for doorstops and other
fixtures.
Q. How is
the cable installed?
A. The heating cable is installed directly under the tiles. For
bathrooms the cable is positioned between the tiler's screed and
the tile. By having the cable immediately below the tile you have a
very responsive heating system. The cable is laid at approximately
60mm spacing and this provides 150 watts per square metre and even
flow of temperature. The cable is connected to a thermostat and
timer so you program and automate the system to suit your
lifestyle.
In most circumstances the cable is protected by self-levelling
screed.
Q. What is on demand
heating?
A. Traditional floor heating systems are based on an in slab
electric element whereby the heat is stored in the slab. On demand
heating means you control the heat when you want it, thus resulting
in a far more efficient and convenient heating application.
Q. Can I
install it myself?
A. Self installation is possible as a continuity alarm is
supplied with every product. This allows you to monitor the cable
while you are tiling and laying the levelling compound. We do
however recommend you utilise our network or registered
installers.
Q. How long does it take to
heat the room?
A. The timer will switch the element on and the tiles will heat
up within 20 minutes. The room will be warm within 30 -60 minutes
depending on the design, ceiling height, and insulation
standards.
Q. Is supplementary Heating
Required?
A. No, provided that the HOTWIRE™ system is installed correctly
and the room is well insulated. Where an existing heating system is
in place, the HOTWIRE™ system can be used as background heating and
keeps your tiles warm under feet.
Q. What is the
warranty?
A. There is a 10 Year manufacturer’s warranty on the heating
cable and a 2-year warranty on the thermostat/timer.
Q. Can it be repaired
easily?
A. Repairing HOTWIRE™ is simpler than you might think and can
generally be done with the removal of only one tile.
Q. Will Hotwire crack the tiles?
A. If installed correctly Hotwire will not damage the tiles or
grout in any way. In fact some of our largest customers Australia
wide are Tile retailers.
Q. Where can I purchase Hotwire Under Tile Heating?
A. We have a number of points of sale throughout stores
throughout Australia. Call 1300 797 060 for your nearest
retailer
Q. Can Hotwire be installed under Carpet or Floating
Floor?
A. Whilst installation under other floor surfaces is possible
Tiles remain the most suitable floor surface. | 